— Oil Temperature Warning Light
This telltale indicates engine oil temperature is high.
If the light turns on while driving, stop the vehicle
and shut off the engine as soon as possible. Wait for
oil temperature to return to normal levels.
— Oil Pressure Warning Light
This light indicates low engine oil pressure. If the
light turns on while driving, stop the vehicle and
shut off the engine as soon as possible. A chime will
sound when this light turns on.
Do not operate the vehicle until the cause is cor-
rected. This light does not indicate how much oil is
in the engine. The engine oil level must be checked
under the hood.
Yellow Warning Lights
— Adaptive Cruise Control (ACC)
Fault Warning Light — If Equipped
This telltale will turn on to indicate a fault in the
ACC system. Contact your local authorized dealer
for service. For further information, refer to “Adap-
tive Cruise Control (ACC)” in “Starting And Op-
erating.”
— Anti-Lock Brake (ABS ) Warning
Light
This light monitors the Anti-Lock Brake System
(ABS). The light will turn on when the ignition is
placed in the ON/RUN or ACC/ON/RUN posi-
tion and may stay on for as long as four seconds.
If the ABS light remains on or turns on while driving,
then the Anti-Lock portion of the brake system is
not functioning and service is required as soon as
possible. However, the conventional brake system
will continue to operate normally, assuming the
Brake Warning Light is not also on.
If the ABS light does not turn on when the ignition is
placed in the ON/RUN or ACC/ON/RUN posi-
tion, have the brake system inspected by an autho-
rized dealer.
— Electronic Park Brake Warning Light
This telltale will turn on to indicate the Electronic
Park Brake is not functioning properly and service is
required. Contact your authorized dealer.
— Electronic Stability Control (ESC) Off
Warning Light — If Equipped
This light indicates the Electronic Stability Control
(ESC) is off.
Each time the ignition is turned to ON/RUN or
ACC/ON/RUN, the ESC system will be on, even if
it was turned off previously.
— Electronic Stability Control (ESC)
Active Warning Light — If Equipped
This light will indicate when the Electronic Stability
Control system is Active. The “ESC Indicator Light”
in the instrument cluster will come on when the
ignition is placed in the ON/RUN or ACC/ON/
RUN position, and when ESC is activated. It should
go out with the engine running. If the “ESC Indica-
tor Light” comes on continuously with the engine
running, a malfunction has been detected in the
ESC system. If this light remains on after several
ignition cycles, and the vehicle has been driven
several miles (kilometers) at speeds greater than
30 mph (48 km/h), see your authorized dealer as
soon as possible to have the problem diagnosed
and corrected.
• The “ESC Off Indicator Light” and the “ESC Indi-
cator Light” come on momentarily each time the
ignition is placed in the ON/RUN or ACC/ON/
RUN position.
• The ESC system will make buzzing or clicking
sounds when it is active. This is normal; the sounds
will stop when ESC becomes inactive.
GETTING TO KNOW YOUR INSTRUMENT PANEL
84
To Next Page
