Vehicles equipped with the Anti-Lock Brake System
(ABS) are also equipped with Electronic Brake
Force Distribution (EBD). In the event of an EBD
failure, the Brake Warning Light will turn on along
with the ABS Light. Immediate repair to the ABS
system is required.
Operation of the Brake Warning Light can be
checked by turning the ignition switch from the
OFF position to the ON/RUN position. The light
should illuminate for approximately two seconds.
The light should then turn off unless the parking
brake is applied or a brake fault is detected. If the
light does not illuminate, have the light inspected by
your authorized dealer.
The light also will turn on when the parking brake is
applied with the ignition switch in the ON/RUN
position.
NOTE:
This light shows only that the parking brake is ap-
plied. It does not show the degree of brake applica-
tion.
— Battery Charge Warning Light
This light illuminates when the battery is not charg-
ing properly. If it stays on while the engine is run-
ning, there may be a malfunction with the charging
system. Contact your authorized dealer as soon as
possible.
This indicates a possible problem with the electrical
system or a related component.
— Door Open Warning Light — If
Equipped
This indicator will illuminate when a door is ajar/
open and not fully closed. This indicator will reflect
which doors are open.
NOTE:
If the vehicle is moving, there will also be a single
chime.
— Electric Power Steering Fault Warn-
ing Light
This light will turn on when there's a fault with the
EPS (Electric Power Steering) system. Refer to
“Power Steering” in “Starting And Operating” in the
Owner’s Manual for further information.
WARNING!
Continued operation with reduced assist could
pose a safety risk to yourself and others. Service
should be obtained as soon as possible.
— Electronic Throttle Control (ETC)
Warning Light
This light informs you of a problem with the Elec-
tronic Throttle Control (ETC) system. If a problem
is detected while the vehicle is running, the light will
either stay on or flash depending on the nature of
the problem. Cycle the ignition when the vehicle is
safely and completely stopped and the transmission
is placed in the PARK position. The light should
turn off. If the light remains on with the vehicle
running, your vehicle will usually be drivable; how-
ever, see an authorized dealer for service as soon as
possible.
NOTE:
This light may turn on if the accelerator and brake
pedals are pressed at the same time.
GETTING TO KNOW YOUR INSTRUMENT PANEL
82
To Next Page
