EasyManua.ls Logo

Chrysler PACIFICA 2018 - Page 98

Chrysler PACIFICA 2018
332 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
The tire pressure will vary with temperature by ap-
proximately 1 psi (7 kPa) for every 12°F (6.5°C).
This means that when the outside temperature de-
creases, the tire pressure will decrease. Tire pressure
should always be set based on cold inflation tire
pressure. This is defined as the tire pressure after
the vehicle has not been driven for at least three
hours, or driven less than 1 mile (1.6 km) after a three
hour period. The cold tire inflation pressure must
not exceed the maximum inflation pressure molded
into the tire sidewall. Refer to “Tires” in “Servicing
and Maintenance” for information on how to prop-
erly inflate the vehicle’s tires. The tire pressure will
also increase as the vehicle is driven. This is normal
and there should be no adjustment for this in-
creased pressure.
The TPMS will warn the driver of a low tire pressure
if the tire pressure falls below the low-pressure warn-
ing limit for any reason, including low temperature
effects and natural pressure loss through the tire.
The TPMS will continue to warn the driver of low
tire pressure as long as the condition exists, and will
not turn off until the tire pressure is at or above the
recommended cold placard pressure. Once the low
tire pressure warning (Tire Pressure Monitoring
Telltale Light) illuminates, you must increase the tire
pressure to the recommended cold placard pres-
sure in order for the “Tire Pressure Monitoring Tell-
tale Light” to turn off.
NOTE:
When filling warm tires, the tire pressure may need
to be increased up to an additional 4 psi (28 kPa)
above the recommended cold placard pressure in
order to turn the Tire Pressure Monitoring Telltale
Light off.
The system will automatically update and the “Tire
Pressure Monitoring Telltale Light” will turn off
once the system receives the updated tire pressures.
The vehicle may need to be driven for up to 20 min-
utes above 15 mph (24 km/h) in order for the TPMS
to receive this information.
For example, your vehicle may have a recom-
mended cold (parked for more than three hours)
placard pressure of 33 psi (227 kPa). If the ambient
temperature is 68°F (20°C) and the measured tire
pressure is 28 psi (193 kPa), a temperature drop to
20°F (-7°C) will decrease the tire pressure to ap-
proximately 24 psi (165 kPa). This tire pressure is
low enough to turn ON the “Tire Pressure Monitor-
ing Telltale Light.” Driving the vehicle may cause
the tire pressure to rise to approximately 28 psi
(193 kPa), but the “Tire Pressure Monitoring Telltale
Light” will still be on. In this situation, the “Tire
Pressure Monitoring Telltale Light” will turn off only
after the tires are inflated to the vehicle’s recom-
mended cold placard pressure value.
NOTE:
When filling warm tires, the tire pressure may need
to be increased up to an additional 4 psi (28 kPa)
above the recommended cold placard pressure in
order to turn the Tire Pressure Monitoring Telltale
Light off.
CAUTION!
• The TPMS has been optimized for the origi-
nal equipment tires and wheels. TPMS pres-
sures and warning have been established for
the tire size equipped on your vehicle. Unde-
sirable system operation or sensor damage
may result when using replacement equip-
ment that is not of the same size, type, and/or
style. The TPM sensor is not designed for use
on aftermarket wheels and may contribute to a
poor overall system performance or sensor
damage. Customers are encouraged to use
SAFETY
96

Table of Contents