GETTING TO KNOW YOUR VEHICLE 115
4. Once the crossbar is in place, tighten both
thumb screws completely.
Installing Crossbars
5. Deploy and tighten the second crossbar to
complete the deployment of the crossbars.
NOTE:
The crossbars are not identical and have fixed
deployment positions. Rear crossbar can be
deployed in two different positions.
STOWING THE CROSSBARS
1. Starting with one crossbar, completely
loosen the thumb screws at both ends. Lift
the crossbar away from the matching letter
to remove it from the deployed position.
Repeat with the other crossbar.
2. Starting with the one crossbar, bend up the
pivot supports at each end.
Crossbar Pivot
3. Then, position the crossbar along the
correct side rail. Make sure the letters on
the crossbar align with the matching letters
on the side rail.
Stowing Crossbars
4. The crossbar will nest fully within the side
rail.
Crossbar To Side Rail
CAUTION!
Use care when removing and handling the
crossbars to prevent damage to the vehicle.
2
21_RUP_OM_EN_USC_t.book Page 115
To Next Page
Loading...
