© CIAS Elettronica S.r.l. Ed 1.1
Installation Manual Page 44 of 51 Sioux Pro 2
3.4 Sioux-Slave-Pro2
Sioux-Slave-Pro2 is a board with a sensor. Six Slave-Pro2 boards can be connected to a Master-
Pro2 board.
The Master-Pro2 board acquires the signals of the sensors present on the Slave-Pro2 boards
and communicates these received signals to the Sioux-CU-Pro2 in digital format.
SiouxPro2-Slave SiouxPro2-Slave +
3.5 Termination
Each branch of the Sioux-CU-Pro2 must be terminated. Insert a termination in the free connector
of the last sensor of each branch.
The Termination is shown below.
This product contains an 82 Ohm resistor to terminate the RS485 serial line and connect the
unused analogue inputs to ground.
To Next Page
Loading...
