HEAT PUMPS - AIR CONDITIONING - REFRIGERATION - AIR HANDLING - HEAT EXCHANGE -
NA 12.78 E
Air handling units for
swimming pools
13
Junior BCP
Input Output
Evaporating
coil
Condensing
coil
Water
auxiliary coil
Outlet fan
Remote condenser
C1
Depending on comfort requirements, this option enables a selection
whereby condensation is carried out inside the installation or outside,
replacing the plate exchanger with a remote air-cooled condenser.
The change of condenser is done using a manual switching device.
With CIATpool electronic control (optional) this change is automatic
according to the ambient temperature.
The air-cooled unit, essentially comprised of a fan(s) and coil can be
selected with a centrifugal fan as from series ASN and ASM or with an
axial fan as from series ASJ and ASW.
Note: These air-cooled units must include the option of condensation
pressure control.
12. REMOTE CONDENSATION
Air-cooled unit transport
The unit must be handled with care to avoid transport damage. Thus
we recommend:
- For large dimension units, appropriate transports should be used to
reach the installation location.
- For transport in a container, one must be selected that has an easy
load and unload to the installation location.
- Do not dispose of the pallet nor the packaging materials until the
machine is in its fi nal location.
- Transport the units using a forklift truck (all series).
Moreover, in the case of the ASJ and ASW series the units can also
be transported using slings however only by the hoisting points on the
unit. The slings must be separated using a strut to avoid deteriorating
the bodywork.
IMPORTANT: The serial number must be used in all
communication regarding the unit.
Unit identifi cation
All unit bear, legibly and indelibly, a data plate located in a prime space,
with the following data:
Positioning and assembly of the
air-cooled unit
Location designation
Before moving the unit, make sure that all panels are fastened in place.
Lift and lower with care.
When choosing the location, in any way the selected fashion, the
following precautions have to be taken into consideration:
- It is mandatory to comply with norm EN 378-3 on Safety and
Environmental Requirements. Part 3: "In situ" installation and
protection to people.
- It is necessary to check that the structure supports the unit's weigh
(please see weighs in technical characteristics sheet).
- The area where the unit will be located must be perfectly accessible
for cleaning and maintenance operations. Leave enough space so
that air can circulate around the unit (please check minimum free
space for maintenance).
- Foresee appropriate bumping devices in all the installation so that
noise and vibration transmission is avoided.
- For each one of the units, certain installation norms must be followed
as well:
Ref. Produit\Item Nbr Designation\Description
An.Y
ear
No Serie\Serial Nbr \ No Produit
Refrigerant kW Absorbee\Input kW Poids\Weight
Refrigerant kg Tension\Voltage Temperature Maxi C
BP Mini PSM\MOP Intensité\Current A IP
HP Maxi PSM\MOP Int.. Kit Elect. No CE
30, av JeanFalconnier
01350 CULOZ
Tel : 33(0)4 79 42 42 42
Made in Spain
Type de réfrigérant
Basse pression
Modèle
Nº ordre commande
Poids en fonctionnement
Tension du réseau
Haute pression
Nº ordre fabrication
Intensité kit electrique
To Next Page
