Cinderella CLASSIC - 2.6 ELECTRICAL SPECIFICATIONS AND REQUIREMENTS

ENGLISH
11
Power requirements
INPUT CURRENT FUSE
220V-240V AC 9 A 10 A
Power consumption
STANDBY MODE INCINERATING MODE
0.5 W 2000 W
Connection polarity
CABLE CROSS SECTION CABLE LENGTH PLUG TYPE
1,5 mm² 2,3 m Type F Schuko CEE 7
2.6 ELECTRICAL SPECIFICATIONS AND REQUIREMENTS
WARNING!
• This appliance must be installed in accordance with National Electrical Codes, as well
as all state, municipal and local codes.
• The correct voltage, frequency and amperage must be supplied to the appliance from
a dedicated, grounded circuit which is protected by a properly sized circuit breaker.
• The proper voltage, frequency and amperage are listed in this manual and on the
product rating plate on the back of the toilet.
DANGER!
• The connection cable must be laid in such a way that it does not come into contact with
sharp edges.
• Changes to the internal electrical installation or the connection cable must be performed
by a professional tradesman or a similarly qualied person in order to prevent safety
hazards.
• Power converters are not recommended for use with your Cinderella product. Cinderella
Classic has a maximum power consumption level of 2000W, which may be sustained over
periods exceeding an hour at a time. Power converters with a “peak consumption” level of
2000W may be unable to maintain this power output and become overloaded, damaged
or unsafe if used with your Cinderella Classic.
2.5.3 INSTALLING THE ORIGINAL CINDERELLA FLUE TERMINAL CAP
Min 10 mm
2 x
NOTE!
The toilet is delivered with a 16 Amp, 250Volt,
2 Pole 3Wire Grounding Type F schuko CEE 7/7 plug.
To supply sucient power to the unit as delivered,
it will require a dedicated grounded circuit, with at
least 10 amps of available power at 230 V AC.
NOTE!
The Cinderella Original installation Kit includes a ue terminal cap that is designed for
optimal ow and increased product eciency. This cap consists of two parts, where the
base section can be xed to the pipes with stainless screws or glue, this for easy connection
and removal for maintenance of the ventilation pipes. Use the 500 mm pipe included in the
Cinderella installation kit as the last section of the ventilation pipe, this will utilize the
connection of the ue terminal cap.