Cinderella CLASSIC - 2.7 CHECKLIST TO VERIFY COMPLETE INSTALLATION; 2.8 PERFORMANCE TEST TO VERIFY SYSTEM FUNCTIONALITY

12
CONTROL ITEMS CONFORMANCE
The connected voltage is in accordance with the appliance rating plate
The appliance is installed in accordance with manufacturers specications
- The vertical ue pipe is installed according to manufacturer specications
- The ue termination is no less than 600 mm from the roof surface
- Safe draining “siphon” is installed where condensation is likely to accumulate
- Flue pipe material is installed according to manufacturer specications
- Flue cap is installed according to manufacturer specications
- 90 degree elbow is installed according to manufacturer specications
2.7 CHECKLIST TO VERIFY COMPLETE INSTALLATION
2.8 PERFORMANCE TEST TO VERIFY SYSTEM FUNCTIONALITY
When the “Start” button is pressed, the incineration cycle will be activated. The estimated incineration time for
the verication test is approximately 60 – 80 minutes. The yellow light will be lit when the incineration is ongoing,
and the complete test should be completed without any fault indications or system interruptions. The toilet will
have to cool down to the point that the fan has stopped before the ash container can be removed. The cooling
phase can take from 60 – 90 minutes, depending on the ambient cooling temperature.
The end result should only be ne white dust. Any end results deviating from this or an incineration time
exceeding 90 minutes may indicate a restriction in the ue vent or a lack of oxygen. Check that the installation is
in accordance with the manufacture specications, presented in section 2 of this manual.
1 meter
1,2 liter
2
1
3
5
64
WARNING!
The ash container will get very hot while incinerating. Do not remove the ash container until
the toilet has cooled completely and the fan has stopped.
60 - 70 minutes
60-80 Minutes