150
FORGE Batch Application Generator User Guide
Time-out 3 sec.
0~255 (second) Set the maximum time for decoding to continue during a scan attempt.
It applies to the following scan modes only –
Aiming mode
Laser mode
Auto Off mode
Aiming Duration 3 sec.
1~255 (second) Set the maximum time for decoding to continue during a scan attempt.
It applies to Aiming mode only.
Picklist Mode Picklist mode enables the decoder to decode only barcodes
aligned under the center of the laser aiming pattern.
Enable
Disable
Disable
1D Inverse Decode 1D Inverse Decoder:
Decode regular 1D barcode only
Decode inverse 1D barcode only
Decode both regular and inverse
Decode
regular 1D
barcode only
Read Redundancy None
None No redundancy means one successful decoding will make the reading valid
and induce the "READER Event".
One time or two times The higher the reading security is (that is, the more redundancy the user
selects), the slower the reading speed gets.
If "Two Times" is selected, it will take a total of three consecutive
successful decodings of the same barcode to make the reading valid.
Mobile Display Mode Decide whether to enable enhanced mobile phone display
in reading barcodes.
Enable
Disable
Disable
Note: Scan Mode options, Decode Illumination, Aiming Pattern, Aiming Duration, Picklist
Mode and 1D Inverse Decoding are supported on 2D scan engine for
8200/8400/8600/8700 only.
To Next Page
Loading...
Need help?
General
