WARNING – Always make sure the input power is completely disconnected before attempting any troubleshooting procedures.
All troubleshooting should be done by a qualified professional.
Check Cell (Flashing) – Error Light
This LED may flash when the cell is nearing the end of its lifepsan.
Troubleshooting:
No troubleshooting is required. The Cell can continue to be used until a solid warnling light occurs, but enough operation
has occurred that you should consider purchasing a replacement cell. The flashing LED light can be cleared by following
the follow the Reprogramming instructions on page 5.
No Power on Display – Non-functional Control Module
Is the pump running? Are all breakers on? Have you verified power going into the unit? If these things are confirmed and
the system is not powering on or reacting, the Control Module must be replaced.
To Next Page
Loading...
