Circutor P119410006000 User Manual

R
R
G
G
U
U
-
-
1
1
0
0
/
/
R
R
G
G
U
U
-
-
1
1
0
0
C
C
e
e
l
l
e
e
c
c
t
t
r
r
o
o
n
n
i
i
c
c
e
e
a
a
r
r
t
t
h
h
l
l
e
e
a
a
k
k
a
a
g
g
e
e
p
p
r
r
o
o
t
t
e
e
c
c
t
t
i
i
o
o
n
n
r
r
e
e
l
l
a
a
y
y
Page 25
Setting measurement SETUP
From measurement SETUP, the parameter settings for the RGU-10/RGU-10C can be displayed and/or changed; this
may match these parameters to the requirements of the system topologies and/or applications. If it is an RGU-10C,
this SETUP menu is preceded by the communications SETUP menu. If there is no communications, RGU-10 is the
only SETUP on the equipment.
The equipment does not save the setting changes until all of the setting has been entered using the PROG button.
When it detects that the keyboard has been inactive for a certain time it displays "EXIT" and the setting menu is
exited it without saving the changes.
(*) RGU-10 only.
On entering setting mode, a screen is displayed informing that the equipment has entered setting mode with the
PROG symbol on the upper section of the first menu screen.
Operating frequency
The display shows FREQ. In order to change this press PROG. The value of the current frequency appears on the
upper left of the screen.
In order to change the operating frequency, repeatedly press the td button increase in the digit in the upper left
corner.
When the value on the screen is the required value, enter and move onto the next menu by pressing the PROG key.
SETUP is exited with the SAVE message.
Scale limit
The display shows LIM. In order to change this press PROG. The final delay scale values and the actual current
sensitivity settings appear on the upper section of the screen.
In order to modify the operational scale, repeatedly press the td button increasing the values of the digits on the
upper section of the screen. There are two scales, one in 10 seconds and 30 Amperes and the other default scale in
1 second and 3 Amperes.
When the required values are shown on the screen they are entered by pressing the PROG button. SETUP is exited
with the SAVE message.
 To access MEASUREMENT SETUP the PROG button has to be pressed to enter setting mode.(*)

Circutor P119410006000 Specifications

General

Brand	Circutor
Model	P119410006000
Category	Relays
Language	English