Need help?Do you have a question about the Circutor RGU-10 and is the answer not in the manual?
General| Power Supply | 230 V AC |
|---|---|
| Mounting | DIN rail |
| Rated voltage | 230 V AC |
| Number of poles | 1 |
| Frequency | 50/60 Hz |
| Contact material | Silver alloy |
| Protection degree | IP20 |
| Electrical life | > 10^5 operations |
| Operating temperature | -10 to +50 ºC |
| Storage temperature | -20°C to +70°C |
| Output Contacts | 1 changeover (CO) |
Warning of risk, which could result in personal injury or material damage.
Indicates points requiring special attention during operation or installation.
Wiring diagram for current emission coil setup.
Procedure for powering the device before the breaking device with undervoltage coil.
Positive safety connection setup using an undervoltage coil.
Troubleshooting steps for trips caused by a poor connection to the earth leakage toroid.
Understanding and resolving pre-alarm conditions.
Method for directly adjusting parameters using the device's buttons.
To Next Page
