Need help?Do you have a question about the Circutor RGU-100A and is the answer not in the manual?
General| Type | Residual Current Relay |
|---|---|
| Power supply | 230 V AC |
| Mounting | DIN rail |
| Frequency | 50/60 Hz |
| Operating temperature | -10 to +50 °C |
| Protection degree | IP20 |
| Output | 1 changeover contact |
| Power consumption | < 3 VA |
| Sensitivity (IΔn) | 30 mA to 3 A |
Essential safety measures and precautions before installing the device.
Instructions for physically installing the device, typically on a DIN rail.
Identifies and lists all connection terminals for the RGU-10A and RGU-100A.
Illustrates the wiring diagrams for connecting the device and associated components.
Describes the fundamental working principle of the earth leakage protection relay.
Configuration screen for setting the trip current threshold of the relay.
Configuration of the trip delay time and the type of trip curve.
Settings related to the pre-alarm relay, including current, delay, and operation modes.
Setting the current threshold for activating the pre-alarm function.
Settings for the main trip relay, including polarity and current limit.
Settings for the RS-485 communication interface, including baud rate and data format.
Details on Modbus commands, memory mapping, and device variables.
Modbus variables used for configuring device parameters.
To Next Page
