Circutor RGU-10 - RGU-10 configuration menu; CONFIGURATION THE MEASUREMENT SETUP; OPERATING FREQUENCY

32
RGU-10, RGU-10C
Instruction Manual
B�- RGU-10 congurationmenu
PROG
td
PROG
td
td
PROG
Figure 31: RGU-10 conguration menu.
5.3.- CONFIGURATION THE MEASUREMENT SETUP
From measurement SETUP, the parameter settings for the RGU-10/RGU-10C can be displayed
and/or changed; this may match these parameters to the requirements of the system topologies
and/or applications
If it is an RGU-10C, this SETUP menu is preceded by the communications SETUP menu. If
there is no communications, RGU-10, is the only SETUP on the device.
The device does not save the setting changes until all of the setting has been entered using the
PROG key. When it detects that the keyboard has been inactive for a certain time it displays
“EXIt” and the setting menu is exited it without saving the changes.
Onenteringcongurationmode,ascreenisdisplayedinformingthatthedevicehasentered
congurationmodewiththePROGsymbolontheuppersectionoftherstmenuscreen.
5�3�1�- OPERATING FREQUENCY
The display shows FREQ. In order to change this press PROG. The value of the current
frequency appears on the upper left of the screen
In order to change the operating frequency, repeatedly press the td button increase in the digit
in the upper left corner.
When the value on the screen is the required value, enter and move onto the next menu by
pressing the PROG key. SETUP is exited with the SAVE message.