To enter setting mode the PROG key must be pressed.
5�4�1�- PERIPHERAL NUMBER
The display shows PERI and the peripheral number on the upper left of the screen.
To write or change the number of the peripheral repeatedly press the td button, increasing the
value of the digit which is in the upper left corner.
When the required value is on the screen, it is entered and the display moves on to the next
menu by pressing PROG key, to allow the remaining values to be changed.
The peripheral number varies between 1 and 99.
5�4�2�- BAUD RATE
The display shows the letters “bd” on the upper left of the screen showing the bauds and shows
the baud rate in units of a thousand in the central part of the screen.
Repeatedly press the td button to change the baud rate, increasing the value of a digits on the
central area of the screen.
When the required value is on the screen, move on to the following digit by pressing PROG, to
allow the remaining values to be changed.
The possible setting values are as follows:
To Next Page
Loading...
