Cirrus Design Section 4
SR20 Normal Procedures
P/N 21399-004 4-7P/N 21399-004 4-7
• Caution •
Serials 2016 thru 2240 before SB2X-32-21: Clean and inspect
temperature indicator installed to piston housing. If indicator
center is black, the brake assembly has been overheated. The
brake linings must be inspected and O-rings replaced.
f. Wheel and Brakes ....... Fluid Leaks, Evidence of Overheating,
General Condition, and Security.
g. Chocks and Tiedown Ropes........................................Remove
8. Nose, Right Side
a. Cowling.....................................................Attachments Secure
b. Exhaust Pipe ....................Condition, Security, and Clearance
c. Gascolator (underside)................Drain for 3 seconds, Sample
9. Nose gear, Propeller, and Spinner
• WARNING •
Keep clear of propeller rotation plane. Do not allow others to
approach propeller.
a. Tow Bar .......................................................Remove and Stow
b. Strut ...........................................................................Condition
c. Wheel Fairing ....................... Security, Accumulation of Debris
d. Wheel and Tire ..........................Condition, Inflation, and Wear
e. Propeller ........................... Condition (indentations, nicks, etc.)
f. Spinner ............................... Condition, Security, and Oil Leaks
g. Air Inlets ..............................................................Unobstructed
h. Alternator Belt....................................... Condition and Tension
10. Nose, Left Side
a. Landing Light.............................................................Condition
b. Engine Oil......... Check 6-8 quarts, Leaks, Cap & Door Secure
c. Cowling.....................................................Attachments Secure
d. External Power .....................................................Door Secure
e. Exhaust Pipe(s) .................Condition, Security, and Clearance
(Continued on following page)
Revision A1
To Next Page
Loading...
