CISA MyEVO - Programming from the External Keypad

- 24 -
Programming from the external keypad
All programming must be performed with the door open.
Programming mode remains active until the administrator has nished or for 15 seconds.
Procedure Signals
1. Adding a user code
Codes preceded by 0000 are not allowed. Up to
30 user codes may be stored.
1.1. Press the CISA writing to activate the keypad;
1.2. Enter the 8-digit Master Code;
1.3. Press 1;
1.4. Enter the user code (from 4 to 8 digits);
1.5. Re-enter the user code.
a. If the operation is successfully completed, 2
short beeps are heard and the
symbol will
ash green twice;
b. otherwise a long beep will be heard and the
symbol will ash red.
2. Deleting the user code
2.1. Press the CISA writing to activate the keypad;
2.2. Enter the 8-digit Master Code;
2.3. Press 2;
2.4. Enter the user code;
2.5. Re-enter the user code.
a. If the operation is successfully completed, 2
short beeps are heard and the
symbol will
ash green twice;
b. otherwise a long beep will be heard and the
symbol will ash red.
3. Deleting all user codes
3.1. Press the CISA writing to activate the keypad;
3.2. Enter the 8-digit Master Code;
3.3. Press 3;
3.4. Re-enter the Master Code.
a. If the operation is successfully completed, 2
short beeps are heard and the
symbol will
ash green twice;
b. otherwise a long beep will be heard and the
symbol will ash red.
4. Changing the length of the user code
It is possible to change the length of the user code only if no codes have been set.
If codes have already been set, repeat the procedure described in point 3 “Deleting all user
codes”
4.1. Press the CISA writing to activate the keypad;
4.2. Enter the 8-digit Master Code;
4.3. Press 4;
4.4. Enter the desired numbers (from 4 to 8
digits).
a. If the operation is successfully completed, 2
short beeps are heard and the
symbol will
ash green twice;
b. otherwise a long beep will be heard and the
symbol will ash red.
EN