Cisco 1000 ISR Series

To Next Page

Install and Connect the Router

This chapter describes how to install and connect Cisco 1000 Series Integrated Services Router (ISR) to LAN

and WAN networks.

Read the installation instructions before using, installing or connecting the system to the power source.

Statement 1004

Warning

Installing the Cisco 1000 Series Integrated Services Routers involve these tasks:

• Unpack the Router, on page 1

• Set up Router on Desktop, Rack, or Wall, on page 1

• Connect Power Cable, on page 19

• Connect the Router to a Console, on page 21

• Connect WAN and LAN Interfaces, on page 25

• Configure the Router at Startup, on page 26

Unpack the Router

Unpack the router only when you are ready to install it. If the installation site is not ready, to prevent accidental

damage, keep the chassis in its shipping container until you are ready to install.

The router, accessory kit, publications, and any optional equipment you order may be shipped in more than

one container. When you unpack the containers, check the packing list to ensure that you have received all

listed items.

Set up Router on Desktop, Rack, or Wall

After unpacking, based on your requirements, you can set up a Cisco 1100 Series Integrated Services Routers

(ISRs) on a desktop, a rack, or the wall.

Install and Connect the Router

Need help?

Do you have a question about the Cisco 1000 ISR Series and is the answer not in the manual?