Section 1: SVP Cisco Wireless LAN Controllers with 1100, 1130, 1140, 1200, 1230, 1240, 1250 APs
PN: 1725-36192-001_H 13
Global settings for RF Channel Assignment and Tx Power Level
Assignment were not tested. For Custom Tx Power and RF Channel
settings please consult your facility’s RF site survey — optimized for
wireless voice traffic — to determine correct power and channel
settings for each AP using only channels 1, 6 and 11.
4. Set Admin Status to Enable.
5. Configure any other settings that might be relevant to your
deployment as needed.
6. Click the Apply button to save all changes.
Screenshot for 1100, 1130, 1200, 1230 and 1240 series access points:
Screenshot for 1140 and 1250 series access points:
7. In the navigation pane under 802.11b/g/n, click Network.
8. Set 802.11b/g Network Status to Disable. The radio will be re- enabled
after setting radio parameters.
For setting up the Data Rates, please consult your facility’s RF site
survey, designed for voice traffic, to determine if you have sufficient
coverage to support all data rates. SpectraLink Wireless
Telephones require the following minimum dBm reading to support
the corresponding Mandatory data rate setting in the access point.
To Next Page
Loading...
