Cisco 1230AG - Aironet - Wireless Access Point - Page 14

VIEW Certified Configuration Guide
PN: 1725-36192-001_H
14
802.11
Radio Standard
Minimum Available
Signal Strength (RSSI)
Maximum
"Mandatory" Data Rate
802.11b
-70 dBm
1 Mb/s
-60 dBm
11 Mb/s
802.11g
-63 dBm
6 Mb/s
-47 dBm
54 Mb/s
802.11a
-60 dBm
6 Mb/s
-45 dBm
54 Mb/s
For additional details on RF deployment please see the Deploying
Enterprise-Grade Wi-Fi Telephony white paper and the Best
Practices Guide for Deploying SpectraLink 8020/8030 Wireless
Telephones.
9. Use the default Fragmentation Threshold (2346 bytes).
10. Set the Beacon Period to 100.
11. The handsets do not support dynamic power and will not utilize the
information element that is set when DTPC Support is enabled. The
handset power should be configured to match the highest transmit
power of the APs. Click the Apply button to save the settings.
12. In the navigation pane under 802.11b/g/n, select EDCA Parameters.
13. Select SpectraLink Voice Priority from the drop-down list.
14. Click the Apply button to save the settings.
15. In the navigation pane under 802.11b/g/n, select Network.
16. Enable 802.11b/g Network Status and 802.11g Support if SpectraLink
Wireless Telephones are configured for 802.11b & b/g mixed mode.
17. Click the Apply button to save the settings.