Cisco 1230AG - Aironet - Wireless Access Point - Page 39

Section 2: WMM Cisco Wireless LAN Controllers with 1100, 1130, 1140, 1200, 1230, 1240, 1250 APs
PN: 1725-36192-001_H 39
8. Under the QoS tab, set Quality of Service to Platinum. This is the
required setting for voice traffic.
9. Set WMM Policy to Required.
10. Under the Security tab. At Layer 2 Security select the desired security
policy from the drop-down list.
a. For WPA2-PSK, under WPA+WPA2 Parameters:
i. Select the WPA2-Policy check box.
ii. Select the AES check box for WPA2-Encryption.
iii. At Auth Key Mgmt select PSK from the drop-down list.
b. For WPA-PSK, under WPA+WPA2 Parameters:
i. Select the WPA-Policy check box.
ii. Select the TKIP check box for WPA Encryption.
iii. At Auth Key Mgmt select PSK from the drop-down list.