25
Quick Start Guide Cisco Aironet 1240AG Series Access Point
6. Click Apply. The access point reboots configured with the power
settings you specified.
Note You might have to refresh your browser screen to see the
current status indicating that the access point radios are
enabled.
Configuring Basic Settings
Before you can configure basic settings, the access point and your PC needs
an IP address. See the “Obtaining and Assigning an IP Address” section on
page 18.
Follow these steps to configure basic settings for the access point using the
GUI Express Setup page.
1. Open your browser, and enter the access point IP address in the address
field. A username and password screen appears.
1. Check the release notes for your power sourcing equipment to determine which Cisco IOS
version supports Cisco Intelligent Power Management. For some PSEs, support for Cisco
Intelligent Power Management might not be available yet.
2. MAC address is the 12- character hexadecimal address of the switch port to which the access
point is attached. The MAC address format is HHHH.HHHH.HHHH.
To Next Page
Loading...
