b) Set the keyed slots over the pegs, and then slide the rail toward the front to lock it in place on the pegs. The front slot
has a metal clip that locks over the front peg.
c) Install the second inner rail to the opposite side of the chassis.
Figure 31: Attach the Inner Rail to Side of Chassis
Locking clip on inner rail2Front of chassis1
Step 2 Open the front securing plate on both slide-rail assemblies. The front end of the slide-rail assembly has a spring-loaded
securing plate that must be open before you can insert the mounting pegs into the rack-post holes.
On the outside of the assembly, push the green arrow button toward the rear to open the securing plate.
Figure 32: Front Securing Mechanism, Inside of Front End
Rack post2Front mounting pegs1
Securing plate shown pulled back to open position3
Step 3 Install the slide rails into the rack:
a) Align one slide-rail assembly front end with the front rack-post holes that you want to use.
The slide rail front end wraps around the outside of the rack post and the mounting pegs enter the rack-post holes
from the outside-front.
The rack post must be between the mounting pegs and the open securing plate.
Note
b) Push the mounting pegs into the rack-post holes from the outside-front.
c) Press the securing plate release button, labeled PUSH. The spring-loaded securing plate closes to lock the pegs in
place.
Cisco Secure Firewall Management Center 1700, 2700, and 4700 Hardware Installation Guide
33
Rack-Mount the Chassis
Rack-Mount the Chassis
To Next Page
Loading...
Need help?
General
