Cisco 2500 Series

Spectralink VIEW Certified Configuration Guide: Cisco Controllers and APs
721-1001-000-AH.docx
December 2016 20
AP Configuration
All handsets operating on a given AP radio must have the same QoS setting. All
APs supporting the handsets must be configured to enable the corresponding
features.
1 Power-on and connect the APs to the network. Wait a few minutes for the APs to find the
controller.
2 Verify the APs are associated to the WLC.
3 From the main menu (Advanced mode in 8.1 and later), click Monitor.
8.1+ versions