Cisco 2500 Series

Spectralink VIEW Certified Configuration Guide: Cisco Controllers and APs
721-1001-000-AH.docx
December 2016 30
2 Disable msdu aggregation:
a Connect to the CLI as described in the section “Configuring a New Controller Starting
from Factory Defaults”.
b Enter the commands:
config 802.11b disable network
config 802.11b 11nsupport a-msdu tx priority all disable
config 802.11b enable network
save config
3 If an 1142 ap is in use, disable mpdu aggregation.
a Connect to the CLI as described in the section “Configuring a New Controller Starting
from Factory Defaults”.
b Enter the commands:
config 802.11b disable network
config 802.11b 11nsupport a-mpdu tx priority all disable
config 802.11b enable network
save config
4 Click the Apply button to save the settings.
5 In the navigation pane under 802.11b/g/n, select Network.
6 For 802.11b/g Network Status, click the Enabled check box.
Configuration for use with 5 GHz radio
1 From the main menu, click Wireless.