Cisco 2500 Series

Spectralink VIEW Certified Configuration Guide: Cisco Controllers and APs
721-1001-000-AH.docx
December 2016 39
b Enter the commands:
config 802.11a network disable
config 802.11a 11nsupport a-msdu tx priority all disable
config 802.11a network enable
save config
3 If an 1142 ap is in use, disable mpdu aggregation.
a Connect to the CLI as described in the section “Configuring a New Controller Starting
from Factory Defaults”.
b Enter the commands:
config 802.11a network disable
config 802.11a 11nsupport a-mpdu tx priority all disable
config 802.11a network enable
save config
4 In the navigation pane under 802.11a/n, select Network.
5 For 802.11a Network Status, click the Enabled check box.
6 Click the Apply button to save the settings.