1
Doc. No.
Cisco Systems, Inc.
All rights reserved.
170 West Tasman Drive
San Jose, CA 95134-1706
USA
Cisco Systems, Inc.
Corporate Headquarters
Copyright © 1998
Installing the Cisco RPS Adapter Plate
in Cisco 2600 Series Routers
Product Number: ACS-2600RPS=
This document describes how to install an adapter plate in Cisco 2600 series routers for use with the
Cisco Redundant Power System (RPS). The Cisco RPS provides power system redundancy to
external devices (such as routers, switches, or hubs). The system includes two fully redundant AC
input power modules and four DC output power modules for connection to external devices. The
Cisco RPS supports quasi-redundant and fully redundant power source configurations. To use the
Cisco RPS with Cisco 2600 series routers, you must remove the existing power supply and replace
it with a Cisco RPS adapter plate.
This document includes the following sections:
• Safety Recommendations on page 1
• Required Tools and Equipment on page 4
• Removing the Cover on page 5
• Removing the Power Supply on page 7
• Installing the Redundant Power Supply Adapter Plate on page 8
• Obtaining Service and Support on page 11
• Cisco Connection Online on page 11
• Ordering Documentation on page 12
Safety Recommendations
Follow these guidelines to ensure general safety:
• Keep the chassis area clear and dust-free during and after installation.
• Put the removed chassis cover in a safe place.
78-5172-01
To Next Page
Need help?
General
