Cisco 2600 Series Installation Guide

Installing the Cisco RPS Adapter Plate in Cisco 2600 Series Routers 5
Removing the Cover
Figure 1 Cisco RPS Adapter Plate for Cisco 2600 series Routers
To install the Cisco RPS adapter plate, you will also need the following tools and equipment (which
are not included):
• Cisco 2600 series router
• Medium-size Phillips screwdriver
• ESD-preventive wrist strap
• Antistatic bag (optional)
• Wire cutters or scissors for cutting the cable tie-wraps (optional)
Removing the Cover
You must remove the chassis cover to access the internal power supply.
Warning Do not touch the power supply when the power cord is connected. For systems
with a power switch, line voltages are present within the power supply even when the
power switch is OFF and the power cord is connected. For systems without a power
switch, line voltages are present within the power supply when the power cord is
connected.
Warning Before performing any of the following procedures, ensure that power is
removed from the DC circuit. To ensure that all power is OFF, locate the circuit breaker
on the panel board that services the DC circuit, switch the circuit breaker to the OFF
position, and tape the switch handle of the circuit breaker in the OFF position.
WARNING:
Lorem ipsum dolor sit amet, consectetuer sed
diam nonummy nibh euismod tincidunt ut
dolore magna aliquam erat volutpat.
H9430
Adapter plate

Cisco 2600 Series Specifications

General

Brand	Cisco
Model	2600 Series
Category	Network Router
Language	English