Cisco 4112 User Manual

a) Locate the hexagonal ventilation hole on the power supply module at the center of the plug just below the power
connector body (see the following figures).
b) Plug the snapping portion of the tie wrap into the hexagonal hole.
c) With the clamp side facing up, push the tie wrap in until it is fully engaged.
Make sure you have the correct location because you cannot remove the tie wrap from the power supply
module once you have installed it without damaging the tie wrap.
Caution
Figure 52: Flextronics Power Supply Module
Hexagonal hole2Flextronics tie wrap1
Figure 53: Artesyn Power Supply Module
Hexagonal hole2Artesyn tie wrap1
Cisco Firepower 4112, 4115, 4125, and 4145 Hardware Installation Guide
75
Installation, Maintenance, and Upgrade
Secure the Power Cord on the AC Power Supply Module

Cisco 4112 Specifications

General

Brand	Cisco
Model	4112
Category	Control Unit
Language	English