1-9
Cisco Secure Router 520 Series Hardware Installation Guide
OL-12892--01
Chapter 1 Product Overview
Regulatory Compliance
Regulatory Compliance
For compliance and safety information, see the Regulatory Compliance and Safety Information for
Cisco
Secure Router 500 Series.
Autosensing function Eliminates the need for a crossover cable and allows the router to detect
medium-dependent interface (MDI) in normal mode or medium-dependent
interface in crossover mode (MDIX) in any other PC or hub by means of a
straight-through cable or a crossover cable. The router is capable of bridging and
multiprotocol routing between the LAN and WAN ports.
10BASE-T/100BASE-T built-in switch
ports
Provides connection to 10/100BASE T (10/100-Mbps) Ethernet networks.
Compatible with 10/100-Mbps devices.
Fast Ethernet WAN port Cisco Secure Router 520 Ethernet-to-Ethernet routers only. Provides connection to
10/100BASE T. Can be connected to other network devices, such as cable modem
and routers.
ADSL-over-POTS port Cisco Secure Router 520 ADSL-over-POTS routers only. Provides connection to an
ADSL network. Does not support the autoswitch function.
ADSL-over-ISDN port Cisco Secure Router 520 ADSL-over-ISDN routers only. Provides connection to an
ADSL-over-ISDN network. Does not support the autoswitch function.
Console port Provides connection to a terminal or PC for software configuration or for
troubleshooting using the CLI. The console port may be configured as a virtual
auxiliary port (using the CLI) for dial backup and remote management.
Router Reset button Resets the router configuration to the factory default.
Wall-mount feature Allows the router to be mounted on a wall or vertical surface.
Rack-mount feature Allows use of brackets to mount the router in a 19-inch rack.
Kensington security slot Allows the router to be secured to a desktop or other surface by using the
Kensington lockdown equipment.
Table 1-2 Cisco Secure Router 520 Series Feature Summary (continued)
Feature Description
To Next Page
Loading...
Need help?
General
