To Next PageTo Next Page
Need help?Do you have a question about the Cisco NCS-57C3-MOD-SYS and is the answer not in the manual?
General| Model | NCS-57C3-MOD-SYS |
|---|---|
| Rack-mountable | Yes |
| Rack Unit Height | 3RU |
| Total Slots | 3 |
| Operating System | Cisco IOS XR |
| Cooling | Front-to-back airflow |
| Product Type | Router |
| Form Factor | Chassis |
| Ports | Varies by installed Modular Port Adapters |
| Power Supply | Dual Redundant AC or DC power supplies |
| Supported Interfaces | Ethernet, Optical |
| Weight | 40 lb (18.14 kg) (fully configured) |
Overview of the Cisco NCS 5700 series fixed-port routers.
Safety guidelines to avoid injury and equipment damage during installation.
NEBS GR-1089-CORE cautions and compliance requirements.
Guidelines to ensure proper site preparation for chassis installation.
Specifies front and rear clearance needed for chassis installation.
Instructions for installing the Cisco NCS 5700 series chassis into a rack.
Procedures for mounting the chassis on a 2-post or 4-post rack.
Steps to ensure the chassis is properly grounded.
Instructions for connecting AC power to the chassis.
Steps for connecting DC power to the chassis.
Steps to assign an IP address and configure the router.
Procedures for installing and removing SFP28 and SFP+ modules.
Installation and removal instructions for QSFP-DD transceiver modules.
Installation and removal instructions for QSFP+/QSFP28 transceiver modules.
Procedures for replacing fan modules and fan trays.
Procedures for replacing route processor cards.
Step-by-step instructions for MPA installation and removal.
Using show commands to verify installation and configuration.
