EasyManua.ls Logo

Cisco 5400 ENCS - Preparing for Installation; Safety Recommendations and Warnings; Safety with Electricity

Cisco 5400 ENCS
54 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
CHAPTER 2
Preparing for Installation
Safety Recommendations and Warnings, on page 17
Safety with Electricity, on page 17
Site Requirements, on page 18
Mounting Requirements, on page 20
Power Guidelines and Requirements, on page 20
Network Cabling Specification, on page 21
Required Tools and Equipment, on page 21
Safety Recommendations and Warnings
Please read the following safety guidelines before you install this product:
Review the safety warnings listed in Regulatory Compliance and Safety Information for the Cisco 5400
Enterprise Network Compute System before installing, configuring, or maintaining the device.
Keep the chassis area clean and dust-free during and after installation.
Keep the chassis in a safe place when you remove the chassis cover.
Do not wear loose clothing that could get caught in the chassis.
Wear safety glasses when working under conditions that might be hazardous to your eyes.
Do not perform any action that creates a hazard to people or makes the equipment unsafe.
Safety with Electricity
Follow these general guidelines when working on equipment that is powered by electricity:
Locate the emergency power-off switch in the room in which you are working. If an electrical accident
occurs, you can quickly turn off the power.
Disconnect all power before doing the following:
Installing or removing a chassis.
Working near power supplies.
Cisco 5400 Enterprise Network Compute System Hardware Installation Guide
17

Table of Contents

Related product manuals