EasyManua.ls Logo

Cisco 5400 ENCS - Installing and Removing a DIMM

Cisco 5400 ENCS
54 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Figure 13: Upgrading the M.2 Storage Module
5. Replace the chassis cover.
Installing and Removing a DIMM
There are two DDR4 DIMM slots. DIMMs have a polarization notch on the connecting edge to prevent
incorrect insertion.
Figure 14: DIMM Showing Polarization Notch
These are the steps to install a DIMM:
1. Remove the chassis cover.
2. Locate the DIMM module on the device.
Cisco 5400 Enterprise Network Compute System Hardware Installation Guide
32
Installing and Upgrading FRUs
Installing and Removing a DIMM

Table of Contents

Related product manuals