14-15
Cisco ASA 5500 Series Getting Started Guide
78-19186-01
Chapter 14 Configuring the CSC SSM
Scenario: Security Appliance with CSC SSM Deployed for Content Security
Step 13 Choose the interface from the drop-down list. Available options are global (all
interfaces), inside, management, and ssm management.
Step 14 Choose the source of network traffic from the IPv4 Network Objects list, and click
OK.
Step 15 To specify the destination of network traffic for the CSC to scan, click the ellipses
to display the Browse Destination dialog box.
Step 16 Choose the destination of network traffic from the IPv4 Network Objects list, and
click OK.
Step 17 To specify the type of service for the CSC to scan, click the ellipses to display the
Browse Service dialog box.
Step 18 Choose the service(s) from the list, and click OK.
Step 19 Enter a description for the network traffic that you want the CSC to scan in the
field provided.
Step 20 To specify whether or not to allow the CSC to scan network traffic if it fails, do
the following:
• To allow traffic through without being scanned, click Permit.
• To prevent traffic from going through without being scanned, click Deny.
• To save your settings, click OK. The added traffic details appear on the
Traffic Selection for CSC Scan screen.
• To discard these settings and return to the Traffic Selection for CSC Scan
screen, click Cancel. If you click Cancel, ASDM displays a dialog box to
confirm your decision.
To Next Page
Loading...
Need help?
General
