Cisco 6000 series Hardware Installation Guide

Contents
v
Cisco Network Convergence System 6000 Series Routers Hardware Installation Guide
OL-29234-02
About Cable Management Brackets 5-3
Installing and Removing an Impedance Carrier 5-4
Installing an Impedance Carrier 5-4
Prerequisites 5-4
Required Tools and Equipment 5-4
Steps 5-4
Removing an Impedance Carrier 5-6
Prerequisites 5-6
Required Tools and Equipment 5-6
Steps 5-6
Installing and Removing an RP Card 5-6
Installing an RP Card 5-6
Prerequisites 5-7
Required Tools and Equipment 5-7
Steps 5-7
Verifying the Installation of an RP Card 5-9
Troubleshooting the RP Card 5-11
Removing an RP Card 5-11
Prerequisites 5-11
Required Tools and Equipment 5-11
Steps 5-12
Installing and Removing a Fabric Card 5-14
Installing a Fabric Card 5-14
Prerequisites 5-14
Required Tools and Equipment 5-14
Steps 5-14
Verifying the Installation of a Fabric Card 5-17
Troubleshooting the FC 5-17
Removing a Fabric Card 5-18
Prerequisites 5-18
Required Tools and Equipment 5-18
Steps 5-19
About Line Cards 5-20
10-Port 100Gbps Line Card with CPAK Optics Module 5-20
10-Port 100Gbps Line Card with CXP Optics Module 5-22
60-Port 10Gbps Line Card with SFP+ Optics Module 5-25
Installing and Removing a Line Card 5-28
Installing a Line Card 5-28
Prerequisites 5-28

Cisco 6000 series Specifications

General

Category	Network Router
Model	Cisco 6000 series
Routing Protocols	BGP, OSPF, EIGRP, IS-IS, RIP
Interfaces	Gigabit Ethernet, 10 Gigabit Ethernet
Ports	Varies by model
Power Supply	Redundant power supply options
Dimensions	Varies by model
Weight	Varies by model
Redundancy	Power supplies, fans, route processors
Operating System	Cisco IOS