To Next PageTo Next Page
Need help?Do you have a question about the Cisco 6000 series and is the answer not in the manual?
General| Category | Network Router |
|---|---|
| Model | Cisco 6000 series |
| Routing Protocols | BGP, OSPF, EIGRP, IS-IS, RIP |
| Interfaces | Gigabit Ethernet, 10 Gigabit Ethernet |
| Ports | Varies by model |
| Power Supply | Redundant power supply options |
| Dimensions | Varies by model |
| Weight | Varies by model |
| Redundancy | Power supplies, fans, route processors |
| Operating System | Cisco IOS |
Lists technical changes made to the document since its initial release.
Provides guidance on accessing Cisco documentation and support services.
Details features introduced or updated in the specified IOS XR release.
Outlines the necessary conditions and user group requirements before preconfiguring interfaces.
Explains key concepts related to the process of configuring interfaces before they are physically present.
Describes how to use the interface preconfigure command for interfaces not yet in the system.
Provides a step-by-step procedure for basic interface preconfiguration.
Lists requirements for configuring management Ethernet interfaces, including user group and task IDs.
Explains concepts related to management Ethernet interfaces and their default settings.
Details the procedure for configuring a management Ethernet interface with minimal required settings.
Outlines requirements for configuring Ethernet interfaces, including task IDs and interface naming.
Explains Ethernet standards and supported interface types on the Cisco NCS 6000 Series Router.
Provides an overview of IEEE standards relevant to Gigabit Ethernet interfaces.
Guides on how to configure various Ethernet interface types, including Gigabit and 10-Gigabit.
Lists requirements for configuring Ethernet OAM, including specific hardware.
Introduces concepts of Ethernet OAM, including link OAM features and configuration methods.
Details the procedures for configuring Ethernet OAM, including creating profiles and attaching them.
Explains how to create and configure an Ethernet OAM profile with various parameters.
Lists requirements for link bundling, including compatible hardware and knowledge of links.
Explains concepts of link bundling, including overview, advantages, and supported methods like LACP.
Provides a high-level overview of link bundling, its purpose, and how it works.
Provides a step-by-step guide for configuring Ethernet link bundles and related settings.
Outlines user group and task ID requirements for configuring virtual interfaces.
Explains concepts of virtual interfaces, including naming conventions and RP behavior.
Details procedures for configuring virtual loopback and null interfaces.
Lists requirements for configuring 802.1Q VLAN interfaces, including prior interface configuration.
Explains 802.1Q VLAN concepts, including tagged frames, subinterfaces, and MTU.
Guides on configuring 802.1Q VLAN subinterfaces on physical interfaces and bundles.
Lists requirements for configuring tunnel interfaces, including user group and task IDs.
Explains tunnel interface concepts, including overview, naming conventions, and IPSec basics.
Details procedures for configuring Tunnel-IPSec interfaces, including profile application.
Lists requirements for configuring DWDM controllers, including user group and task IDs.
Provides information on DWDM support in Cisco IOS XR, based on OTN protocol.
Details procedures for configuring DWDM controllers, including optical parameters and G.709.
Explains the process of IP-in-IP encapsulation and decapsulation for network routing.
