Cisco 6000 series User Manual

PurposeCommand or Action
Example:
• Entering yes saves configuration changes to the
running configuration file, exits the configuration
session, and returns the router to XR EXEC mode.
•
RP/0/RP0/CPU0:router(config-if)# commit
• Entering no exits the configuration session and
returns the router to XR EXEC mode without
committing the configuration changes.
• Entering cancel leaves the router in the current
configuration session without exiting or
committing the configuration changes.
• Use the commit command to save the configuration
changes to the running configuration file and remain
within the configuration session.
Displays MAC accounting statistics for an interface.
show mac-accounting type location instance
Example:
Step 6
RP/0/RP0/CPU0:router# show mac-accounting TenGigE
location 0/2/0/4
Configuring a L2VPN Ethernet Port
Use the following procedure to configure an L2VPN Ethernet port.
The steps in this procedure configure the L2VPN Ethernet port to operate in port mode.
Note
SUMMARY STEPS
1. configure
2. interface [TenGigE] interface-path-id
3. l2transport
4. l2protocol {cdp | pvst | stp | vtp}{[forward | tunnel][experimental bits]|drop}
5. Do one of the following:
• end
• or
• commit
• or
6. show interfaces [TenGigE] interface-path-id
DETAILED STEPS
PurposeCommand or Action
Enters XR configuration mode.configure
Example:
Step 1
Interface and Hardware Component Configuration Guide for Cisco NCS 6000 Series Routers, IOS XR Release 6.4.x
38
Configuring Ethernet Interfaces
Configuring a L2VPN Ethernet Port

Cisco 6000 series Specifications

General

Category	Network Router
Model	Cisco 6000 series
Routing Protocols	BGP, OSPF, EIGRP, IS-IS, RIP
Interfaces	Gigabit Ethernet, 10 Gigabit Ethernet
Ports	Varies by model
Power Supply	Redundant power supply options
Dimensions	Varies by model
Weight	Varies by model
Redundancy	Power supplies, fans, route processors
Operating System	Cisco IOS