RP/0/RP0/CPU0:router(config-if)# ipv4 address
192.168.1.2/32
RP/0/RP0/CPU0:router(config-if)# commit
Additional References
The sections that follow provide references related to the preconfiguration of physical interfaces.
Related Documents
Document TitleRelated Topic
Cisco NCS 6000 Series Router Master Command ListingMaster command reference
Interface and Hardware Component Command Reference
for Cisco NCS 6000 Series Routers
Interface configuration commands
Initial system bootup and configuration information
Cisco IOS XR Task ID Reference Guide
Information about user groups and task IDs
Standards
TitleStandards
—No new or modified standards are supported by this feature, and support for existing standards has not
been modified by this feature.
MIBs
MIBs LinkMIBs
To locate and download MIBs for selected platforms using Cisco IOS
XR Software, use the Cisco MIB Locator found at the following URL:
http://cisco.com/public/sw-center/netmgmt/cmtk/mibs.shtml
There are no applicable MIBs for
this module.
RFCs
TitleRFCs
—
No new or modified RFCs are supported by this feature, and support for existing RFCs has not been
modified by this feature.
Interface and Hardware Component Configuration Guide for Cisco NCS 6000 Series Routers, IOS XR Release 6.4.x
8
Preconfiguring Physical Interfaces
Additional References
To Next Page
Loading...
Need help?
General
