Cisco 6000 series User Manual

How to Perform Advanced Management Ethernet Interface
Configuration
This section contains the following procedures:
Configuring a Management Ethernet Interface
Perform this task to configure a Management Ethernet interface. This procedure provides the minimal
configuration required for the Management Ethernet interface.
You do not need to perform this task if you have already set up the Management Ethernet interface to enable
telnet servers.
Note
SUMMARY STEPS
1. configure
2. interface MgmtEth interface-path-id
3. ipv4 address ip-address mask
4. mtu bytes
5. no shutdown
6. Do one of the following:
• end
• or
• commit
• or
7. show interfaces MgmtEth interface-path-id
DETAILED STEPS
PurposeCommand or Action
Enters XR configuration mode.configure
Example:
Step 1
RP/0/RP0/CPU0:routerconfigure terminal
Enters interface configuration mode and specifies the
Ethernet interface name and notation rack /slot /module
/port .
interface MgmtEth interface-path-id
Example:
RP/0/RP0/CPU0:router(config)# interface MgmtEth
0/RP0/CPU0/0
Step 2
The example indicates port 0 on the card that is installed in
slot 0.
Assigns an IP address and subnet mask to the interface.
ipv4 address ip-address mask
Step 3
Interface and Hardware Component Configuration Guide for Cisco NCS 6000 Series Routers, IOS XR Release 6.4.x
13
Advanced Configuration and Modification of the Management Ethernet Interface
How to Perform Advanced Management Ethernet Interface Configuration

Cisco 6000 series Specifications

General

Category	Network Router
Model	Cisco 6000 series
Routing Protocols	BGP, OSPF, EIGRP, IS-IS, RIP
Interfaces	Gigabit Ethernet, 10 Gigabit Ethernet
Ports	Varies by model
Power Supply	Redundant power supply options
Dimensions	Varies by model
Weight	Varies by model
Redundancy	Power supplies, fans, route processors
Operating System	Cisco IOS