How to Configure Ethernet OAM
This section provides the following configuration procedures:
Configuring Ethernet Link OAM
Custom EOAM settings can be configured and shared on multiple interfaces by creating an EOAM profile in
Ethernet configuration mode and then attaching the profile to individual interfaces. The profile configuration
does not take effect until the profile is attached to an interface. After an EOAM profile is attached to an
interface, individual EOAM features can be configured separately on the interface to override the profile
settings when desired.
This section describes how to configure an EOAM profile and attach it to an interface in the following
procedures:
Configuring an Ethernet OAM Profile
Perform these steps to configure an Ethernet OAM profile.
SUMMARY STEPS
1. configure
2. ethernet oam profile profile-name
3. link-monitor
4. symbol-period window window
5. symbol-period threshold low threshold high threshold
6. frame window window
7. frame threshold low threshold high threshold
8. frame-period window window
9. frame-period threshold lowthreshold high threshold
10. frame-seconds window window
11. frame-seconds threshold low threshold high threshold
12. exit
13. mib-retrieval
14. connection timeout <timeout>
15. hello-interval {100ms|1s}
16. mode {active|passive}
17. require-remote mode {active|passive}
18. require-remote link-monitoring
19. require-remote mib-retrieval
20. action capabilities-conflict {disable | efd | error-disable-interface}
21. action critical-event {disable | error-disable-interface}
22. action discovery-timeout {disable | efd | error-disable-interface}
23. action dying-gasp {disable | error-disable-interface}
24. action high-threshold {error-disable-interface | log}
25. action remote-loopback disable
Interface and Hardware Component Configuration Guide for Cisco NCS 6000 Series Routers, IOS XR Release 6.4.x
49
Configuring Ethernet OAM
How to Configure Ethernet OAM
To Next Page
Loading...
Need help?
General
