Cisco 6000 series - How to Configure 802.1 Q VLAN Interfaces

Destination interface tunnel-ip2
==========================================
Source Interface Dir Status
--------------------- ---- --------------
Te0/6/0/1/9 Rx Operational
Te0/7/0/6/9.1 Rx Operational
Te0/7/0/6/9.2 Rx Operational
Te0/7/0/6/9.3 Rx Operational
Te0/7/0/6/9.4 Rx Operational
Te0/7/0/6/9.5 Rx Operational
Te0/7/0/6/9.6 Rx Operational
Te0/7/0/6/9.7 Rx Operational
Te0/7/0/6/9.8 Rx Operational
Te0/7/0/6/9.9 Rx Operational
/* The following output diaplays the configured traffic mirroring sessions in detail for
the specofoed interface. */
Router# show monitor-session mon1 status detail
Sat May 20 11:26:03.482 UTC
Monitor-session test3 (MPLS-IPv4)
Destination interface tunnel-ip3
Source Interfaces
-----------------
TenGigE0/7/0/6/9.200
Direction: Rx-only
Port level: False
ACL match: Enabled (acl101200)
Portion: Full packet
Interval: Mirror all packets
Status: Operational
TenGigE0/7/0/6/9.199
Direction: Rx-only
Port level: False
ACL match: Enabled (acl101200)
Portion: Full packet
Interval: Mirror all packets
Status: Operational
TenGigE0/7/0/6/9.198
Direction: Rx-only
Port level: False
ACL match: Enabled (acl101200)
/* The following output displays the configured traffic mirroring sessions for the specifed
interface. */
Router# show monitor-session source interface tenGigE 0/7/0/6/9 status internal
Sat May 20 06:13:52.934 UTC
Interface TenGigE0/7/0/6/9 (0x03800370)
SPAN MA:
monitor-session test1 (MPLS-IPv4) (configured globally)
destination interface tunnel-ip2 (0x08000084)
replication direction: Rx-only
port level: False
ACL enabled (acl1)
mirroring first 0 bytes
interval: Mirror all packets
state: up
interface capsulation exists
last PFI error: Success
SPAN EA, location 0/7/CPU0:
monitor-session (MPLS-IPv4)
Interface and Hardware Component Configuration Guide for Cisco NCS 6000 Series Routers, IOS XR Release 6.4.x
101
Configuring Traffic Mirroring
Configure Traffic Mirroring