EasyManuals Logo

Cisco 6800 Series Troubleshooting

Cisco 6800 Series
12 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #6 background imageLoading...
Page #6 background image
Handset Doesn't Respond to Key Presses
Problem
Nothing happens when you press a key on the handset.
Cause
The keypad is probably locked.
Solution
Press and hold the star (*) key for 2 seconds to unlock the keypad.
Handset Beeps Continuously While in the Charger
Problem
The handset beeps continuously when placed in the charger.
Solution
Check these scenarios:
The handset wasn’t placed in the charger so that the contacts on the handset and charger touched.
The handset is new and this is the first time it has been placed on the charger. Check that the plastic on
the battery has been removed.
If none of the scenarios apply, the battery may be defective. Put a battery that you know works into the handset
and place the handset in the charger. If the handset doesn’t beep, then the original battery is defective.
Handset Screen Displays "Searching"
Problem
The handset displays the message Searching.
Cause
The handset is too far from the closest base station or the base station isn’t active.
Solution
If the handset has been stationary, the base station may be rebooting or inactive.
1. Wait a couple of minutes to see if the handset can communicate with the base station.
2. If the problem persists, check that the base station has power and the LED is green. If the handset
power was off while searching for the base station, it takes more time to register after the handset
power is on.
Troubleshooting
6
Troubleshooting
Handset Doesn't Respond to Key Presses

Other manuals for Cisco 6800 Series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco 6800 Series and is the answer not in the manual?

Cisco 6800 Series Specifications

General IconGeneral
AudioWideband audio
Ethernet10/100/1000 Mbps
Power over Ethernet (PoE)IEEE 802.3af/at
USBUSB
SIPYes
Supported ProtocolsSIP
Codec SupportG.711, G.722, G.729, iLBC

Related product manuals