Hardware Installation
• Installation Requirements, on page 1
• Install the Base Station, on page 6
• Mount the Base Station or Repeater on the Ceiling, on page 7
• Mount the Base Station or Repeater on a Desk, on page 11
• Mount the Base Station or Repeater on the Wall, on page 12
• Install the Battery in the Handset, on page 16
• Set Up the Charging Cradle, on page 19
• Charge the Handset Battery, on page 19
Installation Requirements
The Cisco IP DECT 6800 Series is made up of the following hardware:
• 6825 Handset
• 6825 Ruggedized Handset
• 6823 Handset
• 110 Single-Cell Base Station
• 210 Multi-Cell Base Station
• 110 Repeater
The 110 Single-Cell Base Station can't be used in the multicell system.
Note
Before you begin to set up the Cisco IP DECT 6800 Series system:
• Determine the number of users (handsets) that are required.
• Determine the number of phone lines (numbers) that are required. Each user can have up to 2 lines and
2 concurrent calls, if the supported total number of concurrent calls on the system aren’t reached.
• Given the number of handsets, determine the number of base stations required, based on:
Hardware Installation
1
To Next Page
