Set Up the Charging Cradle
You use the charging cradle to charge the handset. The cradle has a built-in USB cable that plugs into the
power adapter. The power adapter is designed for your country's electrical outlet configuration and power
rating.
The charging cradle with 6825 Handset and 6825 Ruggedized Handset has a USB port on the side of the
cradle and an LED indicator in the front of the cradle. The side USB port doesn't have supported use at this
time. The LED indicator is lit when the handset is charging.
The charging cradle shipped with 6823 Handset doesn't have the USB port and the LED indicator. You can
also use the charging cradle of 6825 Handset to charge this handset.
Procedure
Step 1 Place the cradle on a level surface.
Step 2 Plug the USB connector of the power cord into the power adapter.
Step 3 Plug the power adapter into the electrical outlet.
Figure 5: 6825 Handset and 6823 Handset Charging Cradle
Charge the Handset Battery
You use the handset charger to charge the handset battery.
The battery comes partially charged, but you should charge it for a minimum of 10 hours before you use it for
the first time. If you don't fully charge it, you may decrease the life of the battery.
Note
If you remove and replace the battery from the handset, you need to fully discharge and then fully charge the
battery so that the battery indicator is accurate.
Hardware Installation
19
Hardware Installation
Set Up the Charging Cradle
To Next Page
Loading...
Need help?
General
