EasyManuals Logo

Cisco 6800 Series Hardware Installation

Cisco 6800 Series
20 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #18 background imageLoading...
Page #18 background image
The battery contacts are on the top left edge of the battery and the top left edge of the battery compartment.
Ensure that the contacts meet and that the battery is seated in the compartment.
The battery fits only one way in the compartment. Don’t force the battery in the wrong way in the
battery compartment.
Note
Step 5 Replace the battery cover, make sure that the cover is closed, and turn the latch clockwise to the locked
position.
Don't force the cover closed. If it doesn't close easily, take it off and check that the battery is completely seated
in the battery compartment.
What to do next
Before you use the handset, you need to charge it. See Charge the Handset Battery, on page 19.
Hardware Installation
18
Hardware Installation
Install the Battery in the Handset

Other manuals for Cisco 6800 Series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco 6800 Series and is the answer not in the manual?

Cisco 6800 Series Specifications

General IconGeneral
AudioWideband audio
Ethernet10/100/1000 Mbps
Power over Ethernet (PoE)IEEE 802.3af/at
USBUSB
SIPYes
Supported ProtocolsSIP
Codec SupportG.711, G.722, G.729, iLBC

Related product manuals