Charge the battery with the handset charger provided. If you use another method, you can damage the battery,
the handset, or your surrounding area.
Caution
Only charge the battery in environments where the temperature is between 32°F (0°C) and 104°F (40°C).
Don’t charge the battery in hazardous environments or where there’s explosion danger.
Caution
When you place the handset into the charger, it turns on (if not already on) and displays a message that the
handset is charging. The handset screen dims and turns off at the configured time.
If the LED on the handset starts to flash, the handset is updating its firmware.
Before you begin
Set up the cradle as described in Set Up the Charging Cradle, on page 19.
Ensure that your handset charger is plugged into the electrical outlet.
Procedure
Place the handset in the charger so that the contacts in the handset and the contacts in the charger match.
The handset beeps, screen turns on, and displays a message that the handset is charging. If this doesn't happen,
remove the handset from the charger and try again.
If the handset beeps continuously while on the charger, try the troubleshooting solution available in the section
Handset Beeps Continuously While in the Charger.
Hardware Installation
20
Hardware Installation
Charge the Handset Battery
To Previous Page
Loading...
Need help?
General
