5-29
Cisco Unified IP Phone 6921, 6941, 6945, and 6961 Administration Guide for Cisco Unified Communications Manager 8.6 (SCCP and SIP)
OL-24567-01
Chapter
Enabling EnergyWise on the Cisco Unified IP Phone 6921, 6941, 6945, and 6961
Table 5-4 explains the Cisco Unified Communications Manager Administration fields that control the
EnergyWise settings. You configure these fields in Cisco Unified Communications Manager
Administration in the Product Specific configuration window, by choosing Device > Phone.
Table 5-4 EnergyWise Configuration Fields
Field Description
Enable Power Save
Plus
Selects the schedule of days for which the phone powers down. Select
multiple days by pressing and holding the Control key while clicking on the
days for the schedule.
By default, no days are selected.
When Enable Power Save is checked, you receive a message to warn about
emergency (e911) concerns.
Caution While Power Save Plus Mode (the mode) is in effect, endpoints
configured for the mode are disabled for emergency calling and
from receiving inbound calls. By selecting this mode, you agree
to the following: (i) You are taking full responsibility for
providing alternate methods for emergency calling and receiving
calls while the mode is in effect; (ii) Cisco has no liability in
connection with your selection of the mode and all liability in
connection with enabling the mode is your responsibility; and (iii)
you will fully inform users of the effects of the mode on calls,
calling and otherwise.
Note To disable Power Save Plus, you must uncheck the Allow
EnergyWise Overrides check box. Leaving the Allow EnergyWise
Overrides checked with no days selected in the Enable Power Save
Plus field does not disable Power Save Plus.
Phone On Time Determines when the phone automatically turns on for the days selected in
the Enable Power Save Plus field.
Enter the time in this field in 24 hour format, where 00:00 is midnight.
For example, to automatically power up the phone at 7:00 a.m. (0700), enter
7:00. To power up the phone at 2:00 p.m. (1400), enter 14:00.
The default value is 00:00.
Phone Off Time The time of day that the phone powers down for the days selected in the
Enable Power Save Plus field. If the Phone On Time and the Phone Off Time
fields contain the same value, the phone does not power down.
Enter the time in this field in 24 hour format, where 00:00 is midnight.
For example, to automatically power down the phone at 7:00 a.m. (0700),
enter 7:00. To power down the phone at 2:00 p.m. (1400), enter 14:00.
The default value is 24:00.
Phone Off Idle
Timeout
The length of time that the phone must be idle before the phone powers
down.
The range of the field is 20 to 1440 minutes.
The default value is 60 minutes.
To Next Page
Loading...
Need help?
General
