17
Settings
To adjust your Cisco Unified IP phone settings menu displayed on the LCD screen, use one of the following methods:
• Press the Settings button to access the menu.
• Press the Volume button to navigate through the list.
The following is a comprehensive list of settings and associated keypad numbers. Functionality will vary according to your
system configuration.
Setting Number Setting
1
Handset volume
2
Speaker volume
3
Ring volume
4
Model info
5
LCD contrast
6
Network configuration
7
Ring type
8
Timers
Operating Your Cisco Unified IP Phone
Place a Call
Use one of the following methods to place a call:
• Lift the handset and dial a number.
• Press the Line button and dial a number.
• Press the Speaker button and dial a number. The Mute button automatically lights, indicating that the called party cannot
hear you.
Note The Cisco Unified IP Phone 7910G does not support two-way speakerphone operation. The Speaker button provides a
hands-free listen-only mode that allows you to hear a phone conversation or messages, but does not permit you to be
heard. To speak to the other party, you must use the handset. If you are using the handset, the Mute button can be
toggled on and off to mute and activate the handset microphone.
• Press a Speed button.
Answer a Call
• Lift the handset.
End a Call
Use one of the following methods to end a call:
• Hang up the handset.
• Press the Speaker button (if using the speaker).
• Press the Line button.
To Next Page
Loading...
Need help?
General
