If you uncheck all channels in the 802.11 G Power Settings or 802.11 A Power Settings, the phone will
not be able to access the WLAN.
Note
Related Topics
Network Profile Settings
USB Settings Field
You can change the IP address of the USB port on your phone by choosing one of the following options in
the DHCP Enabled field:
Yes
Obtains an IP address automatically.
No
You can specify the IP address and subnet mask on this page.
Related Topics
Set Up USB Settings on PC
Trace Settings Fields
You can configure trace settings to determine how the phone creates and saves trace files. The following table
describes the trace settings.
Table 3: Trace Settings
DescriptionItem
Choose the number of trace files that the phone saves, from 2 to 10 files.Number of Files
Set up a remote server to store trace logs. If enabled, enter remote address and
remote port.
Enable Remote Syslog
Enter remote IP address if Enable Remote Syslog is enabled.Remote IP Address
Enter a port number if Enable Remote Syslog is enabled. Valid values are: 514
and 1024 to 65535.
Remote Port
Operating System data.Kernel Level
Phone configuration data.Configuration Level
Cisco Unified Communications Manager data.Call Control Level
Cisco Unified Wireless IP Phone 7925G, 7925G-EX, and 7926G Administration Guide
11
Wavelink Avalanche Server
USB Settings Field
To Next Page
Loading...
Need help?
General
