Cisco 7925G-EX Administration Guide

◦
Avalanche Management Console
•
Cisco Unified Wireless IP Phone 7925G, 7925G-EX, and 7926G Firmware Release 1.3(1) or later
•
Configuration Utility (CU) for Wavelink Avalanche
•
DHCP server
•
Cisco Unified Communications Manager
Best Practices
This section describes the best practices recommended for setting up and using the CU on the Wavelink
Avalanche server.
•
Ensure that the phone is registered to Cisco Unified Communications Manager.
•
Try out this process with one or two phones before deploying to many phones.
•
Set up a VLAN that has access only to the Wavelink server.
•
Configure DHCP Option 149 with the Wavelink server IP address. If you do not configure this option,
see Set Up Wavelink Server Address from Phone, on page 2.
• Configure a Cisco Access Point to use a default SSID of “cisco” with open authentication and no
encryption.
Wavelink Server IP Address Setup
If you did not configure DHCP Option 149 with the Wavelink server IP address, you must manually assign
it.
Do not perform this task if you previously configured the Wavelink server address using DHCP Option
149.
Note
The following sections describe the methods to assign the Wavelink server on the phone.
Set Up Wavelink Server Address from Phone
To assign the Wavelink server from the phone, follow these steps.
Cisco Unified Wireless IP Phone 7925G, 7925G-EX, and 7926G Administration Guide
2
Wavelink Avalanche Server
Best Practices

Cisco 7925G-EX Specifications

General

Brand	Cisco
Model	7925G-EX
Category	IP Phone
Language	English